Greddy MAP Boost Line Feed

[Dzaster]

Here's the deal. I'll be running my stock MAP sensor with a in-line check valve and have it clamped by the EMB under boost--where then the EMB would then resort to the Greddy MAP sensor for MAP signal under boost.

My question is, would it be okay to run the Greddy Boost Feed line before the throttle plate to should it be taken right from the intake manifold?

Reason being is I'd like to keep the Greddy MAP on it's on Boost Feed line and I have an extra port before the throttle plate that used to be for the charcoal canister, but is now open.

So the Greddy MAP sensor would see boost just not vacuum. Will that be a problem?

[Dzaster]

I found that I have enough ports on the intake mani to accomodate everything. I do however, have my boost gauge T'd off the greddy map boost liine.

Should be okay right?

[Accord2nrz]

yes it will be fine, all the vacuum lines see the same amount of vacuum and boost as it occurs.

[Dzaster]

Okay, cool. Getting this thing on and then I will be coming forth with the tuning questions.