EMB budget harnesses

[Kennymp3]

Here is a solution for the ignition harness for the EMB by using the
RX-7 radio harness. I'm still looking for a budget version for the
main harness.
Originally posted by Dzaster
I've got a good pinout diagram for the Emanage blue pinouts. If you weren't concerned about resale, you could solder the wires needed straight to the pinouts of the EMB. If I were in a pinch, I would definitely do that, heat
shrink tubing, and resin(thanks for the idea Travvy:thumbup:) the whole recepticle
:iwdumbass:
That works.....has been done more than once.

Check this out for a cheap alternative for the ignition harness....(2nd post down)
http://www.ozhonda.com/forum/showthread.php?90994-quick-emanage-tips-and-tricks

Originally posted by Weq
1) The ignition harness for our cars is can be easily mocked up. Its only two wires. The plug is the same plug found RX7 series 5-7 headunit plug.


Here's a link over on ebay with a pic of the RX-7 headunit plug......
http://cgi.ebay.com/Metra-70-7901-Mazda-1990-Up-Head-Unit-Wiring-Harness-/130352159005?

http://i207.photobucket.com/albums/bb167/kennymp3/Jumper%20Harnesses/RX7plug.jpg
http://i43.tinypic.com/2enw1tx.jpg

Cool part is that RX7 head unit/ignition plug for the EMB over
on ebay is only $5.50 shipped.
I wonder if anyone is brave enough to see if it really works

[Accord2nrz]

I mocked up my ignition and injection harnesses with those wires. Works just fine for me :)

[ade1964]

Looking at the pic on ebay link, it appears to be the female plug and not a male plug which is what is required, that is unless its a generic picture
anyone bought and used one of these?
thanks
Ade

[TheWooz]

I used a rx7 reverse radio plug worked perfect. They have them on ebay cheap. Just get the right year and you should be good

[Dzaster]

Looking at the pic on ebay link, it appears to be the female plug and not a male plug which is what is required, that is unless its a generic picture
anyone bought and used one of these?
thanks
Ade
Nah you want the one kennyu has picture. The male side.

[Kennymp3]

I was planning on buying one just to check to see if it works,
but if Accord2nrz says it's a go....then it must work.:D

[ade1964]

Have you got a link to the male version?
thanks
Ade

[Accord2nrz]

I was planning on buying one just to check to see if it works,
but if Accord2nrz says it's a go....then it must work.:D

I'll have to take a picture of mine and post it up but yeperz its a go.

[Kennymp3]

Have you got a link to the male version?
thanks
Ade
What male plug are you looking for Ade?
Do you already have the EMB main harness(Big Plug)? if so that RX-7 harness will work for the injector/ignition input on the EMB(Small plug)