PDA

View Full Version : Anti Engine Stall Feature

Dzaster
04-05-2009, 10:59 AM
Since installing this EMB my Anti Engine Install feature has been unselectable(greyed out)
http://i525.photobucket.com/albums/cc340/dzaster96799/Tuning/AES.png

I was reading on another forum where a guy suggested that you had to set your throttle position when the car is off to unlock the Anti Stall. Is that how it is unlocked? And "off" as in engine off, but key to "On" and EMB connected to computer right? I don't know, since that is how I set up my TP in the first place.

The reason I am extra curious about this is because when I'm cruising at low RPM in like 1st or 2nd just like rolling in traffic at like 2000rpm, the engine just kinda cuts like I hit fuel cut or just totally let off the gas. Is this what the Anti Engine Stall feature takes care of or am I dealing with something else. It'll just cut for a couple seconds and go again. Never had that prob when the motor was N/A.
Accord2nrz
04-05-2009, 05:31 PM
The anti engine stall feature works in just that fashion. Most older cars using map sensors that can not read boost act alittle funny after a significant boosting event. 5+ or more normally. To "unlock" it you have to calibrate your TP.

Switch the ign on to activate the emb. and fire up your support tool.
Under the parameter settings click on calibrate tps.
the emb will guide u through setting it from there,

what it does is it locks in the voltage values for 0% throttle, (cruising off the gas or idleing) and WOT 100% throttle.
Dzaster
04-09-2009, 04:17 AM
Ah hah! Perhaps that is my problem then. However, I thought I had it set. I will try it again using these instruction here.

You to cool Accord.:cool:
sventhemac
04-10-2009, 08:24 AM
any luck? Hopefully the anti-stall is that simple with the ultimate. Or does that unlock another map?
Dzaster
04-11-2009, 06:35 AM
any luck? Hopefully the anti-stall is that simple with the ultimate. Or does that unlock another map?
I believe it unlcoks the "ES", engine stall map.

And nah, I haven't had the chance. Been working like a horse. Have some modding to do this weekend as well as tuning.
sventhemac
04-12-2009, 02:57 AM
I know what you mean by working to much, I have a couple of things that I want to install but haven't had the time,EMU and LC1 plus the gauges and related sensors.